Wolf · Chicago, IL
Oven Repair
Built-in wall ovens and the oven half of a range — calibration drift measured against a probe rather than the display, convection faults, door and hinge work, and control boards that have locked themselves out.
How it gets described on the phone
- Forty minutes of preheat and the thermometer on the shelf still says a hundred degrees under the setpoint
- Convection fan starts, rattles, then quits partway through a bake
- Door will not latch square any more and the gasket hangs proud at one corner
- Panel shows an F-code and the door stays locked after a self-clean cycle
What gets measured on the visit
- Probe on the middle shelf through a complete preheat and a hold, logged against the display
- Oven sensor resistance measured cold and again at temperature, because one reading proves nothing
- Bake and broil elements or burners watched through ignition and cycling
- Convection fan draw and blade clearance, and whether it slows once the cavity is hot
- Door gasket compression, hinge spring tension and latch alignment at all four corners
The panel is a report, not evidence. A control that has lost its sensor will keep displaying a number it is no longer measuring, and it will display it very convincingly. So the probe goes in first and stays in, and everything else — calibration offset, sensor, board, gas pressure — is judged against what the shelf says rather than against what the front of the appliance says.
What it tends to come to
Bands, not quotes
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
- Igniter or spark module$190 – $470
- Burner valve or orifice service$260 – $550
- Oven thermostat or sensor calibration$210 – $440
- Convection fan or motor$280 – $600
- Control board or touch panel$430 – $930
- Door hinge, glass or seal$260 – $700
These are the ranges these repairs land in, parts and labour together. The number that matters is the one you are given on the visit, after the readings and before anything is ordered — and you can say no to it. For scale, $8,260 – $18,840 is a comparable professional range, before installation and ventilation work.
What people say afterwards
4.9 out of 5 · 753 reviews
A grinding noise from the back whenever convection ran. Fan bearing had failed. He replaced the motor and while he was in there cleaned out years of debris that had been feeding the wear.
Marguerita V. · Logan Square
Door had dropped and would not sit flush, so heat came out along the top edge. Hinges had worn. He fitted new ones, aligned the door square, and the whole front stopped getting hot.
Aurelius F. · Wicker Park
Both cavities ran cool and I had been compensating with the dial for two years. He measured the real temperature at three points, replaced a sensor, and now the number on the front means something.
Wanda K. · North Center
Preheat took the best part of forty minutes and then it gave up holding. The bake element had a hairline break you could only see from underneath. He spotted it and had the part on the van.
Lorcan D. · Portage Park
Lower cavity had stopped broiling while everything else worked. He tested the element and the relay separately, found the relay, and did not charge me for the part I did not need.
Barnaby C. · Portage Park
It locked itself with a fault code the night before a family dinner. He read the stored history the next morning, found an intermittent latch, and replaced the assembly rather than resetting it.
Zofia N. · North Center
Tell us what it is doing, not what you think it is
The symptom is enough to start with. Dispatch takes the model, the fault and the address, and books the window it can actually keep.
$89 service call, credited against the repair · On site 8:00 am – 8:00 pm, seven days
